Suzhou Dongye Precision Molding Co.,Ltd.
Plastic Parts,Electronic Plastic Parts,Circuit Board Plastic Parts,Injection Molded Plastic Parts
Suzhou Dongye Precision Molding Co.,Ltd.
Plastic Parts,Electronic Plastic Parts,Circuit Board Plastic Parts,Injection Molded Plastic Parts
Due to the incompressibility of water, the water front creates a solid interface, squeezing the inner wall of the product into a cavity, and the water front also acts as a rapid cooling. Therefore, the water supplement has many advantages over the gas supplement. Research and application show that the water supplement can produce thinner and more uniform cavity wall, and the inner surface of the flow channel is very smooth. Especially for thick wall workpiece, the cooling time can be greatly reduced compared with gas auxiliary.
High gloss injection molding: Highlights the basic process of injection molding is prior to injection molding, through the use of high temperature and high pressure steam will mould surface rapidly warming, the forming die cavity surface temperature of resin plastic glass transition temperature (Tg) above, then the plasticizing good plastic melt into the closed mold cavity, the injection stage, mold temperature by high temperature and high pressure steam remains the same, When the injection is finished, the air supply is stopped, and the water vapor in the pipe is blown clean by air pressure of the air pipe. After that, the cooling water is injected to make the mold temperature drop rapidly until the mold is cooled and the product is removed by opening the mold
